zahader
94downloads
My little Under desk drawer! It has dimensions of 140x200x40 mm (WLD). It perfectly fits scissors, pencils, pens, etc. It is easy to print, and takes about 300 grams of plastic. no supports are needed when printing. I used a line thickness of 0.5mm and 0.3 layer height to print faster The drawer is attached to the table with two screws. To do this, there are two large holes (12 mm) in the case so that you can get in with a screwdriver. The facade is inserted into the drawer and glued. The handle is attached with a M3 screw or you can simply glue it. I recommend exposing the seam to the side that is attached to the table when printing the main body. This is necessary so that the seam does not interfere with opening the drawer. I also used transparent scotch tape to improve drawer sliding. There is another smaller hole on the upper part of the main body. It serves to install the screw as a limiter so that the drawer does not fall out. The screw should be with a countersunk head and not be very long so that the drawer can be installed. I'm not sure how the Drawer will work when printing ABS. There may be problems due to shrinkage. This is my first project, I will be glad to get feedback:)